Rockford-fosgate 500.2 Bedienungsanleitung PDF herunterladen (Seite 31)

– 28 –

500.2 S

PECIFICATIONS

Dynamic Power Rating (IHF-202 Standard) - Measured at 14.4V

Per channel into a 4Ω load 450 Watts

Per channel into a 2Ω load 730 Watts

Bridged into a 4Ω load 1460 Watts*

Continuous Power Rating (Competition Standard) - Measured at 13.8 Battery Volts

RMS continuous power per channel, both channels driven

into a 4Ω load from 20 to 20,000Hz with less than

0.05% THD (Total Harmonic Distortion) 250 Watts

RMS continuous power per channel, both channels driven

into a 2Ω load from 20-20,000Hz, with less than 0.10% THD 500 Watts

RMS continuous power mono, into 4Ω load

from 20-20,000Hz, with less than 0.10% THD 1000 Watts

Common Mode Rejection Ratio (CMRR): Typically 40dB

Signal-to-Noise Ratio: >100dB (A-weighted)

Frequency Response: 20Hz-20,000Hz ±0.5dB

Bandwidth: 10Hz–250kHz ±3dB

Damping Factor @ 4Ω (at output connector): >200

Slew Rate: 50V µs

IM Distortion (IHF): <0.05%

Input Impedance: 20k Ohms

Source Unit Compatibility (+15dB gain overlap): 34V max.

Input Sensitivity (+0dB gain overlap): Variable from 350mV to 6V

Pass-Thru Output: Unity Gain

B+ Fuse Size: (External to amplifier) 100 Amp or two 50 Amp

Fuse Type: (1) ANL / (2) AGU

Crossover Slope: 12dB or 24dB/octave Butterworth

Factory Crossover Frequency: 80Hz (0.047µf)

Factory Default Crossover Setting: Full Range

Dimensions: (including end caps) 9-5/8"W x 18-9/32"L x 2-5/8"H

(24.4cm) x (46.43cm) x (6.6cm)

Specifications subject to change without notice.

*This is the calculated Dynamic Power Rating. Actual output power exceeded the input capability of the PowerCube.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 41 42

Keine Kommentare

Rockford-fosgate 500.2 Bedienungsanleitung Seite 31