Rockford Fosgate T2500-1bd Bedienungsanleitung PDF herunterladen (Seite 9)

OPERATION

REMOTE PUNCH EQ (Option)

NOTE: Previous (prior to 2007) Punch Bass and Para-Punch

remotes will not work with these amplifiers.

NOTE: Use the instructions that came with the

remote for a variety of mountings that fit

your preference.

Quick Install

1. Using the screws supplied,install the mounting

clip.

2. Slip the remote onto the mounting clip until it snaps into

place.

3. Route and connect the cable to the remote and amplifier.

Operation

4. Operation works the same as Punch EQ,see below.

NOTE: Connecting the optional remote overrides the Punch EQ

control on the amplifier.

CAUTION: Overexcursion and subsequent damage may occur at high levels of boost.

+20

-2

-0

+10

+12

+14

+16

+18

100 200 500

Low Pass

PUNCH EQ

Turning the knob clockwise increases the bass boost from 0 to +18dB @ 45Hz.Set this to your personal

preference while listening to the system.

NOTE:Connecting the optional remote overrides the Punch EQ control on the amplifier.

ADJUSTING GAIN

To adjust the gain setting,turn the amplifier gains all the way down (counter-clockwise).Turn the source unit

volume up until distortion is audible and then turn it down a bit until the distortion is inaudible.This will be

about all the way up on most source units.Next,increase the amplifier gain setting until adequate volume is

achieved.

NOTE:Best signal to noise and dynamic range are realized with the gain at minimum.

CAUTION: Avoid setting the amplifier gain very high as noise and distortion will

increase significantly.

NOTE: For a more in depth setting procedure,contact Rockford Technical Support.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 71 72

Keine Kommentare

Rockford Fosgate T2500-1bd Bedienungsanleitung Seite 9