Rockford-fosgate RFX9000 Bedienungsanleitung PDF herunterladen (Seite 6)

INSTALLA

TION

INSTALLATION CONSIDERATIONS

The following is a list of tools needed for installation:

Volt/Ohm Meter #2 Phillips screwdriver

Wire strippers Battery post wrench

Wire crimpers Soldering iron

Wire cutters Solder

1/8" diameter heatshrink tubing Heat gun

This section focuses on some of the vehicle considerations for installing your new Source

Unit. Pre-planning your system layout and best wiring routes will save installation time.

When deciding on the layout of your new system, be sure that each component will be

easily accessible for making adjustments.

CAUTION: If you feel unsure about installing this system yourself, have it installed

by a qualified Rockford Fosgate technician.

CAUTION: Before installation, disconnect the battery negative (-) terminal to pre-

vent damage to the unit, fire and/or possible injury.

Before beginning any installation, follow these simple rules:

1. Be sure to carefully read and understand the instructions before attempting to install the

Source Unit.

2. For safety, disconnect the negative lead from the battery prior to beginning the installation.

3. For easier assembly, we suggest you run all wires prior to mounting your Source Unit in

place.

4. Route all of the RCA cables close together and away from any high current wires.

5. Use high quality connectors for a reliable installation and to minimize signal or power loss.

6. Think before you drill! Be careful not to cut or drill into gas tanks, fuel lines, brake or

hydraulic lines, vacuum lines or electrical wiring when working on any vehicle.

7. Never run wires underneath the vehicle. Running the wires inside the vehicle provides the

best protection.

8. Avoid running wires over or through sharp edges. Use rubber or plastic grommets to pro-

tect any wires routed through metal, especially the firewall.

ALWAYS protect the battery and electrical system from damage with proper fusing. Install

the appropriate fuse holder and fuse on the +12V power wire within 18” (45.7 cm) of the

battery terminal.

10. When grounding to the chassis of the vehicle, scrape all paint from the metal to ensure a

good, clean ground connection. Grounding connections should be as short as possible and

always be connected to metal that is welded to the main body, or chassis, of the vehicle.

1 2 3 4 5 6 7 8 9 10 11 ... 79 80

Keine Kommentare

Rockford-fosgate RFX9000 Bedienungsanleitung Seite 6